Controlers

Senzor IR contactless

View

10.79€ with TAX

DALI bus power supply

View

40.00€ with TAX

FLOOR Dimmer

View

37.25€ with TAX

DC DIMER DALI-PUSH-0/10V

View

24.75€ with TAX

Senzor IR contactless

VD09 series hand sweep contactless sensor is designed for switching on / off and dimming 12/24 V LED strips installed in an aluminum profile. It is controlled without direct physical contact using a palm movement. *To function properly the IR sensor must be open and exposed with no plastic cover over top. * small dimensions, high sensitivity sensor, with stable operation through the diffuser at a distance of up to 5 cm. (Need to drill the diffuser) * very easy installation of the switch on an adhesive base on a profile; * wide contact pads for soldering; * LED light indicator that indicates the device status,3000K; * dimming function with last state memory. When the voltage is applied, the device is set to standby mode. The lighting is turned off, and the indicator LED glows warm white. Switching on and off is carried out by a single raising of the hand to the place of installation of the switch in the area of the indicator. Dimming of lighting occurs when you hold your hand in the glow area of the switch indicator.

View

10.79€ with TAX

DALI bus power supply (DALI power supply POW1)

DL-POW1 is a newly developed DALI BUS Power Supply, up to Class 2 power supply standard and SELV safety extra-low voltage standard; It's with short-circuit protection and low-voltage protection; The case is with anti-fire material.
Parameters:
Input Voltage: AC100~240V 50/60Hz
Input Current: 115Vac/≤0.09A, 230Vac/≤0.05A
Inrush Current: Cold start 10A at 230Vac
Output Voltage: DC16V
Output Current: 250mA Max
Rated Power: 4W
Weight: 70g
Safety:
Isolation Resistance: I/P-O/P: 100Mohm/500VDC/25°C/70%RH

View

40.00€ with TAX

FLOOR Dimmer (FLO 24 dim)

Floor dimmable Led Driver
For control of intensity 24V lamps up to 40W

• For independent mounting - IP20 - Insulation Class II
• Pedal adjustment with end-of run switch
• Output in steady voltage 24VDC, +/-5%
• Self-resetting protection against overtemperatures
against open circuit and against output short circuits.
• Input voltage: 100V ÷ 250V/AC, +/- 10% - Steady output.
• Not suitable for systems with switch on the secondary side.

View

37.25€ with TAX

DC DIMER DALI-PUSH-0/10V

Interface/adapter between DC 12-24V input voltage and DC 12-24V LED strip or module.
Control mode:

DALI
PUSH button, NO voltage signal
0-10V/1-10V

Connection voltage 12-24VDC
Power 144W/288W

View

24.75€ with TAX